Need help?Do you have a question about the Alliance Laundry Systems UW60B2 and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | UW60B2 |
| Category | Washer |
| Language | English |
Explains safety terms like DANGER, WARNING, CAUTION.
Lists fundamental safety precautions for operating the washer.
Continues listing essential safety instructions for user protection.
Presents specific WARNING and CAUTION statements regarding installation and operation hazards.
Explains warning symbols related to electrical, chemical, heat, and mechanical hazards.
Details safety measures for machine operators and checks to perform.
Discusses requirements for an appropriate operating environment for safety.
Covers effects of ambient temperature, humidity, ventilation, and elevation.
Continues operator safety, focusing on specific warnings and machine checks.
Details requirements for water pressure, steam, drainage, and electrical power.
Continues operator safety with warnings about inserting hands and balance systems.
Warns against using flammable fluids and spraying water on the machine.
Specifies requirements for foundation strength and service/maintenance space.
Discusses water pressure, steam heat, drainage, and grounding requirements.
Advises replacing panels and not bypassing safety devices.
Lists models UW35B2 and UW60B2 covered by this manual.
Describes where to find the machine's nameplate for serial and model numbers.
Instructs how to obtain literature or replacement parts from the manufacturer.
Provides contact information for technical assistance and service.
Explains the components of the model number for identification.
Illustrates a typical machine nameplate with key details.
Identifies major operational features of the washer-extractor using a diagram.
Describes the control unit's function, intelligence, and PC board.
Explains the power supply and switching devices on the output PC board.
Details the modular nature of wiring harnesses for inputs and outputs.
Illustrates and labels components of the domestic and international control panels.
Summarizes key features like LED indicators, displays, and operating modes.
Lists and explains various display codes and their meanings.
Continues the list of display codes and their meanings.
Guides the user through loading the machine and starting a cycle.
Continues operating instructions, covering supply use and cycle selection.
Outlines daily tasks: inspect hoses, wires, door interlock, clean gasket/dispenser.
Specific daily checks for hoses, wires, and door interlock before operation.
Daily tasks like cleaning, drying, and leaving the door open.
Details monthly maintenance procedures, including bearing lubrication for UW60.
Details bearing lubrication for UW60 models (Design 1-4) using specific grease.
Explains how to check and adjust V-belt tension and alignment.
Outlines quarterly tasks: tighten fasteners, check drain shield, clean filters.
Provides tips for cleaning and maintaining stainless steel surfaces to prevent corrosion.
A checklist for daily inspection and cleaning tasks.
A checklist for weekly inspection and leak checks.
A checklist for monthly lubrication and belt checks.
A checklist for quarterly tasks like tightening fasteners and cleaning filters.
To Next Page
