Introduction
F232135
8
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Replacement Parts
If literature or replacement parts are required, contact
the source from which the machine was purchased or
contact Alliance Laundry Systems at (920) 748-3950
for the name and address of the nearest authorized
parts distributor.
Customer Service
For technical assistance, call (920) 748-3121, Ripon,
Wisconsin U.S.A.
Remove After Shipment (OPL
Models Only)
A yellow retainer has been inserted in the door locks
of all cabinet hardmount on-premise laundry washer-
extractors to prevent the door from locking during
shipment. Remove the yellow retainer during
installation by pulling it off.
NOTE: Once retainer is removed, machine must be
powered to unlock door.
A tag has been attached to the washer-extractor’s door
handle as a reminder that the retainer must be removed
before operation. Refer to Figure 3.
Figure 3
CFS503N
Remove Yellow Retainer
Before Starting Machine.
Note: A Retainer has been
inserted to prevent the door from
locking during shipment.
To Next Page
Loading...
