To Next Page
M
Melissa AndrewsAug 1, 2025
What to do if my Alliance Laundry Systems Washer has no extract (2 Speed Models)?
- SSandra VasquezAug 1, 2025
If your Alliance Laundry Systems Washer isn't extracting, try these steps: Add or edit the extract step in the programming. Also, add or edit the drain step in the programming. Replace the contactor, and check the motor contactor and wiring to the motor. Verify the J16 plug is intact and that there is continuity through NC contacts on FWD and REV contactors KM3 and KM4. Repair or replace the contactor if needed. Check connectors and overload settings, and reset if tripped.
General
