To Next PageTo Next Page
Need help?Do you have a question about the Alliance Laundry Systems DCG020ND and is the answer not in the manual?
General| Brand | Alliance Laundry Systems |
|---|---|
| Model | DCG020ND |
| Category | Washer |
| Capacity | 20 lb |
| Frequency | 60 Hz |
| Height | 43 inches |
| Control Type | Microprocessor |
| Cycle Options | Multiple |
| Type | Commercial |
Lists all applicable model numbers for this manual.
Provides foundational knowledge about the control and its features.
Keypads used to select specific machine cycles.
Keypads used to select water temperature for wash fill.
Describes the function of LEDs indicating cycle status and options.
Details the use of digits for time, price, and error messages.
Explains how to program cycle parameters and vend options.
Describes how to retrieve stored machine usage data.
Details how to run specific diagnostic tests on the machine.
Overview of the advanced programmable computer control.
Explains manual, infra-red, and network programming methods.
Keypads for selecting cycle modifier options like Deluxe and Ultra.
Describes dash sequences during heating or cool down steps.
Allows returning to Ready Mode if vend price is not satisfied.
Details how the machine resumes after a power interruption.
Indicates current cycle and selected modifiers, showing vend price.
Mode entered after START keypad press to lock door and begin cycle.
Allows control communication via IrDA, card reader, or network.
Step-by-step guide to accessing manual programming.
Outlines the structure of Manual Mode: Programming, Rapid Advance, Diagnostics.
Detailed list and description of all programmable options.
Explains how to determine values for day enable settings.
Sets the default cycle modifier for Ready Mode.
Instructions on interpreting retrieved audit data.
Step-by-step guide to resetting machine to factory defaults.
Procedure for accessing diagnostic testing modes.
Overview chart of available diagnostic tests and their displays.
Displays the control software version number.
Displays the drive board software version number.
Tests coin drop #1 functionality.
Displays temperature sensed at the thermistor in 5°F increments.
Tests the 24 VDC supply status.
Checks for water leaks by monitoring water level changes.
Procedure to initiate the factory test mode.
Steps to activate the rapid advance feature.
Explains the symbols and abbreviations used in cycle charts.
