Door Unlocking Mode
This mode is entered when there is no time left in the cycle or
when pausing the cycle while in Run Mode. The door will unlock
after the basket stops spinning. The display will continue to flash
the remaining cycle time every second or if the next mode is End
of Cycle Mode, it will flash 01 every second. If the next mode is
Pause Mode, the display will flash PAUSE every second. If the
drive board determines that the water temperature is too hot to
drain or unlock the door, the display will flash Hot in addition to
the other displays.
Door Unlocking Mode will proceed once the water temperature
drops below 120° F [49° C] .
The machine will always drain water down to an empty level be-
fore attempting to unlock the door. If after draining, the water
level is still not low enough, the control will enter Machine Error
Mode with a drain error, if enabled. Otherwise the control will
continue to drain until it sees the machine empty.
The START (enter) keypad can be pressed while in this mode as
long as Machine Error Mode or End of Cycle Mode is not the
next mode. If the START (enter) keypad is pressed and the next
mode is Pause Mode or Start Mode, the next mode entered will
be Door Locking Mode. Otherwise the press is invalid. All other
keys are invalid while in this mode. Once Door Unlocking Mode
is exited, the control will enter the next mode.
End of Cycle Mode
When a cycle is complete, the control will display OPEN for one
(1) second and DOOR for one (1) second until the washer is
opened, a keypad is pressed, or a coin/card is entered. When one
(1) of these options occur, the display will revert back to the
Ready Mode.
Run Mode
The control enters this mode when a cycle is running. The time
remaining appears in the display, the status LEDs are lit and the
loading door is locked.
Upon the start of a cycle, the display shows a single moving LED
until the machine is ready to rotate the basket. Once the machine
is ready to rotate the basket, the display showes the total cycle
time. The appropriate LEDs will light while the machine passes
through different cycle steps. Any coin entered after the first Fill
step will be added to the total coin counter, but the user will not
be able to change cycles or cycle modifiers.
Signals
The options for when a signal can be used during the machine op-
eration are listed below:
1. End of Cycle Signal - By default, this signal is turned off. If
turned on, the signal sounds for three (3) seconds at the end of
a cycle.
2. Signal On Keypad Depression - By default, this signal is
turned on and sounds for a quarter of a second each time a
keypad is pressed.
3. Signal On Coin Input/Card Insertion - By default, this sig-
nal is turned on and will sound for a quarter of a second each
time a coin or card is entered.
4. Signal for Card Removal (Card Models Only) - By default,
this signal is turned on and will sound one (1) second on and
one (1) second off when the control is prompting for card re-
moval.
5. Signal for Start - By default, this signal is turned on and will
sound one (1) second on and one (1) second off for 10 sec-
onds after vend price has been satisfied.
NOTE: Refer to Programming Control to program signal
options.
Changing Cycles
Selecting a higher priced cycle, wash temperature or soil level
will pause the first Fill Step, and Coins/Card will flash one (1)
second on and one (1) second off until the vend price has been
satisfied. After the vend price has been satisfied, the cycle will
continue with the new selections. If the vend price is not satisfied
within one (1) minute, the machine control will go back to the
previously set cycle, wash temperature and soil level.
Machine Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
23 Part No. F8615401ENR4
To Next Page
Loading...
