Alliance Laundry Systems DCG020ND - Water Temperature Indicator Tp Ind; Speed Units Sunits

Water Temperature Indicator tP ind
This option allows the owner to enable or disable the diplay to
show the actual fill temperature during the fill, supply, agitate, or
soak step by lighting the LED corresponding to the actual tem-
perature.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until tP ind appears in
the display.
4.
When tP ind appears in the display, press the START (en-
ter) keypad. The current status will appear in the display.
on = Option Enabled
oFF = Option Disabled (factory default setting)
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Speed Units SUnitS
This option allows the owner to program the speed units to be
shown in RPMs or G Force for all speed related programming pa-
rameters.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until SUnitS appears in
the display.
4.
When SUnitS appears in the display, press the START (en-
ter) keypad. The current Speed Units status will appear in the
display.
rPN = Option
gForCE = Option
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
112 Part No. F8615401ENR4