Special Vend 4 Days of Week Enable
SP4
This option allows the owner to enable or disable a fourth special
vend. Special Vend 4 can be programmed using an external de-
vice or network. The owner may also turn the Special Vend 4 op-
tion on or off if desired.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until SP4 appears in the
display.
4.
When SP4 appears in the display, press the START (enter)
keypad. The current Special Vend 4 Days Enable status will
appear in the display.
on = Option Enabled
oFF = Option Disabled (factory default setting)
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Cycle Modifier Programming Menu
CNP-
This option allows the owner to program the machine to offer an
added prewash, extra wash time, an added extra rinse, a warm
rinse, or any combination of the above to the customers for an
added vend price. This option is selected when Deluxe or Ultra is
selected using the modifier keypads.
Default Cycle Modifier CNP 1
This option allows the owner to set the Default Cycle Modifier.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNP- appears in the
display.
4.
When CNP- appears in the display, press the START (enter)
keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable Cycle Modifier options until CNP
1 appears in the display.
6.
When CNP 1 appears in the display, press the START (enter)
keypad. A number will appear in the display. This number
corresponds to the current default cycle modifier. Refer to Ta-
ble 10 .
CNP 1
Default Value Cycle Modifier
0 Regular
1 Deluxe
2 Ultra
Table 10
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to in-
crease or decrease the current number to the desired number
selected from the table.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
77 Part No. F8615401ENR4
To Next Page
Loading...
