Programmable Close Door Display
PCdL
This option allows the owner to enable or disable allowing the
control to display the corresponding command to close the door
along with the cycle time.
1. Control must be in Manual Mode. Refer to How to Enter the
Manual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until PCdL appears in the
display.
4.
When PCdL appears in the display, press the START (enter)
keypad. The current status will appear in the display.
on = Option Enabled (factory default setting)
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programmable Push Start Display PPSt
This option allows the owner to enable or disable allowing the
control to display the corresponding command to press the
START (enter) keypad once the vend has been satisfied.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until PPSt appears in the
display.
4.
When PPSt appears in the display, press the START (enter)
keypad. The current Push Start status will appear in the dis-
play.
on = Option Enabled (factory default setting)
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
113 Part No. F8615401ENR4
To Next Page
