Flush Out Drain Valves for Fill Steps
(Models with Pump Drain) FLSH v
This option allows the owner to program the global flush out for
fill steps drain valve selection which will evacuate water at the
beginning of the step which helps clean out the tub and prevent
the excess dirty water from mixing with the fresh water.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until FLSH v appears in
the display.
4.
When FLSH v appears in the display, press the START (en-
ter) keypad. The current status will appear in the display.
1 = Drain 1
2 = Drain 2
3 = Both
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Flush Out Time for Fill Steps (Models
with Pump Drain) FLSH t
This option allows the owner to set the flush out time in seconds
for Fill Steps that have flush out enabled. The flush out is used to
help rinse out the machine at the beginning of the Fill Steps. The
water will be evacuated for the programmed time at the begin-
ning of the Fill Steps that have this option enabled.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until FLSH t appears in
the display.
4.
When FLSH t appears in the display, press the START (en-
ter) keypad. A number will appear in the display. This number
corresponds to the current setting.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
61 Part No. F8615401ENR4
To Next Page
