Hold Step Custom Messages Menu
CNESS-
This option allows the owner to program the machine to display a
custom hold step message when a hold step is programmed.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNESS- appears in
the display.
4.
When CNESS- appears in the display, press the START (en-
ter) keypad. There are two (2) programmable Hold Step Cus-
tom Message options.
Display
Hold Step Custom
Message Options
CNESS1
Custom Message #1
CNESS2
Custom Message #2
Table 26
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current option.
6. Press the START (enter) keypad to change the first of six (6)
programmable characters.
NOTE: To go back to the current programmable op-
tion without changing the value, press the Warm (<)
keypad.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the active character and the START (enter) keypad to
enter the value of the character and advance to the next char-
acter.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programmable Cycle Time Display Ena-
ble PCyCtd
This option allows the owner to program the machine to display a
chosen cycle time in minutes instead of the calculated cycle time.
The cycle time display will not pause for fills or heating. The dis-
play will switch to 01 if the end of the cycle is reached before the
time display reaches 01. If the time displayed reaches 01 before
the end of the cycle, the display will pause at 01 until the cycle
ends.
In order to use this option, the owner must set the programmable
cycle time in a cycle to a value greater than 0. Refer to How to
Enter Cycle Programming CyCLE-.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until PCyCtd appears in
the display.
4.
When PCyCtd appears in the display, press the START (en-
ter) keypad. The current Cycle Time Display value will ap-
pear in the display.
on = Cycle time displayed as programmed
oFF = Calculated remaining cycle time is displayed
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current value.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
103 Part No. F8615401ENR4
To Next Page
