Card Reader Display Control (If Equip-
ped) CArd
This option allows the owner to allow the card reader to drive the
machine's display.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CArd appears in the
display.
4.
When CArd appears in the display, press the START (enter)
keypad. The current status will appear in the display.
0 = FEC Controls Display
1 = Card Reader Controls Display
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
53 Part No. F8615401ENR4
To Next Page
Loading...
