Alliance Laundry Systems DCG020ND - OPL Delayed Start Opl 2; OPL Display Power Save Opl 3

OPL Delayed Start oPL 2
This option allows the owner to enable delayed start mode which
can delay the cycle up to a maximum of 72 hours.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL- appears in the
display.
4.
When oPL- appears in the display, press the START (enter)
keypad to enter the OPL submenu.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL 2 appears in the
display.
6.
When oPL 2 appears in the display, press the START (enter)
keypad. The current OPL status will appear in the display.
on = Option Enabled
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
OPL Display Power Save oPL 3
This option allows the owner to enable the OPL Display Power
Save Feature. If enabled, after 255 seconds of no user input, the
control will turn off all LEDs and the display until user input oc-
curs. The OPL Display Power Save Feature will only turn off the
display if the control is in Start Mode.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL- appears in the
display.
4.
When oPL- appears in the display, press the START (enter)
keypad to enter the OPL submenu.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL 3 appears in the
display.
6.
When oPL 3 appears in the display, press the START (enter)
keypad. The current OPL status will appear in the display.
on = Option Enabled
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
116 Part No. F8615401ENR4