Pause Mode
Pause Mode is entered when the START (enter) keypad is press-
ed three (3) times within five (5) seconds during the first three (3)
minutes of a running machine cycle. This mode is only manually
accessible if the Pause/Resume Mode (Enable/Disable) parameter
is programmed to Enabled and if the control is in Run Mode or
Door Locking Mode . Pause Mode is unavailable during Rapid
Advance and while the machine is in OPL Mode.
If this mode is entered the control will pause the cycle, enter
Door Unlocking Mode, and drain/pump the water out. After the
machine is confirmed to be empty and not rotating, the control
will unlock the door. The control will then enter Pause Mode.
The user may then restart the machine by pressing the START
(enter) keypad, where the machine will enter Door Locking Mode
and once the door locks, the cycle will resume from where it left
off.
NOTE: The display will show PUSH and StArt, the Cy-
cle Selection LEDs will be lit, and if the door is locked,
the door lock LED will be lit.
Closing Washer Door
If the door is not closed when the vend price is satisfied, CLoSE
and door will be displayed until the door is closed. Once the
door is closed, the START (enter) keypad must be pressed to lock
the door and start the cycle. E dL1 will be displayed, indicating
a door lock error, on the third attempt. The machine will attempt
to lock for one additional minute. If the door fails to lock, the
control will return to Start Mode.
If the door locks, the door lock error will clear and the cycle will
continue normally. The door can be opened to clear the door lock
error as well.
Auto-Flush Mode
The Auto-Flush Mode is only available if enabled in the Control
Configuration (refer to Cycle Programming CyCLE-). The pro-
grammable Auto-Flush option allows the control to be set to au-
tomatically flush the dispenser compartments at predetermined
intervals and times. The option may be enabled or disabled. Au-
to-Flush is entered if the following conditions are met.
1. It must be enabled in the Programming Parameters.
2. The machine is in Ready Mode, Start Mode with OPL Mode
active and not in Power Recovery, or Shutdown Mode with the
door closed.
3. The pre-programmed number of cycles have occurred since the
last Auto-Flush.
4. The current day-of-week matches the programmed day-of-
week.
5. The current hour matches the programmed hour.
If these conditions are met, then the control displays FLUSH and
flushes the dispenser compartments with hot water for a pre-pro-
grammed number of seconds (factory default is 80 seconds) or
until the pressure sensor senses water up to the door level. Each
of the four (4) compartments flushes for one quarter of the pro-
grammed time.
Overflow Mode
If the control is not running a cycle, in Door Locking Mode or in
Door Unlocking Mode, then the overflow level is set at the basket
of the machine. In Overflow Mode, if the door is closed, the door
will lock, the pump will turn on, and the gravity drain will open
until the water level is below the overflow reset level if running a
cycle, otherwise the machine will drain until the drum is seen
empty.
If Overflow Mode Display is disabled and the control is in Run
Mode when it exits, the display will show the default Run Mode
display, otherwise in all other cases, the display will show oFLo.
If the door locks and the overflow level is no longer being met
within five (5) minutes of first detecting the overflow, the cycle
will continue as normal and the control will go back to the mode
it was previously in. If the control continues to see an overflow
level after five (5) minutes has been reached with the door
locked, the control will enter Machine Error Mode with an Over-
flow Error.
Machine Operation
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
24 Part No. F8615401ENR4
To Next Page
