Display Identification
Light Emitting Diodes (LEDs)
Light Emitting Diodes (LEDs) are used to indicate the chosen cy-
cle, cycle status, if vend is needed and door lock information. See
below for information on each LED.
CYCLE LED
Cycle LED will remain lit the entire cycle.
WASH TEMP LED
Wash Temp LED will remain on until the end of the cycle or will
change to show the rinse temperature if programmed to do so.
WASH LED
Wash LED is lit at the beginning of the pre-wash and wash por-
tions of the cycle and will remain lit until the wash is complete.
RINSE LED
Rinse LED is lit at the beginning of a rinse portion of the cycle
and will remain lit until the rinse is complete.
SPIN LED
Spin LED is lit during the final spin portion of the cycle.
COINS/CARD LED
Coins/Card LED prompts the user for coins or a card to satisfy
the vend price. digits show the vend price remaining to be satis-
fied. The vend price displayed will decrease with each coin in-
serted. If new options are selected during the first Fill step of the
wash cycle and it requires additional vend, the Coins/Card light
will flash one (1) second on and one (1) second off, and the dis-
play will show the vend price remaining to be satisfied.
DOOR LED
Door LED will flash when the control is attempting to lock or un-
lock the door.
Regular LED
Regular LED is lit when the Option Regular modifier is selected.
Deluxe LED
Deluxe LED is lit when the Option Deluxe modifier is selected.
Ultra LED
Ultra LED is lit when the Option Ultra modifier is selected.
Six 7-Segment Digits
The 7-Segment Digits are used to display the time remaining in a
cycle, vend price, error messages and descriptive codes. During
diagnostic testing or manual programming of the control, these
digits will display descriptive codes and values (as described in
Entering the Manual Mode).
Heating/Cool Down Display Sequence
(Heat Models)
For models with heat, a series of dashes appear on the display to
indicate either heating or cool down during a wash cycle step.
When the machine is heating during an agitate step (refer to Pro-
gramming the Agitate Step Type) or a soak step (refer to Pro-
gramming the Soak Step Type), the cycle time pauses and the dis-
play shows dashes appearing from left to right. The ascending
dash sequence repeats until the water has reached the program-
med temperature. This display only shows durring the initial
heating process.
When the machine is in a cool down step (refer to Programming
the Cool Down Step Type), the cycle time pauses and the display
shows dashes disappearing from left to right. The descending
dash sequence repeats until the water has reached the program-
med temperature.
Display Identification
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
19 Part No. F8615401ENR4
To Next Page
