Alliance Laundry Systems DCG020ND - No Cycle Time Display Ncyctd; Number of Balance Attempts Bal at

No Cycle Time Display nCyCtd
This option allows the owner to program the machine to display
no cycle time instead of the cycle time being displayed, a single
dashed line will move horizontally across the display for the en-
tire cycle.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until nCyCtd appears in
the display.
4.
When nCyCtd appears in the display, press the START (en-
ter) keypad. The current No Cycle Time Display status will
appear in the display.
on = Option Enabled
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Number of Balance Attempts bAL At
This option allows the owner to program the machine's number of
balance attempts with no loss of time. The machine will spin at
an adjusted speed as a result of the last balance attempt, if more
than one (1) attempt is preformed.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until bAL At appears in
the display.
4.
When bAL At appears in the display, press the START (en-
ter) keypad. The current Number of Balance Attempts with no
Loss of Time will appear in the display.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current value.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
104 Part No. F8615401ENR4