OPL Parameters oPL-
This option allows the owner to enable or disable the OPL Pa-
rameters in which no vend price needs to be satisfied to operate
the machine.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL- appears in the
display.
4.
When oPL- appears in the display, press the START (enter)
keypad to enter the OPL submenu.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the OPL submenu options.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
6. Press the START (enter) keypad when the desired option ap-
pears in the display.
OPL Mode Enable oPL 1
This option allows the owner to place the control in OPL Mode,
in which no vend price needs to be satisfied in order to start the
machine. If the control is in Start Mode, the cycle time will be
displayed. Pressing the START (enter) keypad will start the ma-
chine cycle. Once a machine cycle has been started, each addi-
tional press of the START (enter) keypad will advance the cycle
to the next cycle step only if Rapid Advance Programming Pa-
rameter is Enabled.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL- appears in the
display.
4.
When oPL- appears in the display, press the START (enter)
keypad to enter the OPL submenu.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until oPL 1 appears in the
display.
6.
When oPL 1 appears in the display, press the START (enter)
keypad. The current OPL status will appear in the display.
on = Option Enabled
oFF = Option Disabled
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
115 Part No. F8615401ENR4
To Next Page
