Machine Configuration Parameters
Menu MCP-
The Machine Configuration Parameters Menu shows which
valves are on the machine or if there is a thermistor installed.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until MCP- appears in the
display.
4. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options (refer to Table 27 ). Press
the START (enter) keypad to enter the desired option. The
current status will appear in the display.
Parameters
MCP 1
Compartment Valve Set
Present
MCP 2
Fill Tub Valve Set Present
MCP 3
Spray Valve Set Present
MCP 4
Cold Hard Fill Valve Present
MCP 5
Auxiliary Valve Present
MCP 6
Unused
MCP 7
Unused
MCP 8
Thermistor Present
Table 27
0 = Item is not present
1 = Item is present
5. Press the Warm (<) keypad to exit the parameter.
Lucky Cycle Menu LUC-
This option allows the owner to program the machine to provide
a free or reduced vend cycle to users after a certain number of
machine cycles have occurred.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until LUC- appears in the
display.
4.
When LUC- appears in the display, press the START (enter)
keypad. There are three (3) programmable Lucky Cycle op-
tions. Refer to Table 28 .
Display Lucky Cycle Options
LUC 1
Lucky Cycle Day(s) of
Week / Enable (refer to Ta-
ble 9 )
LUC 2
Lucky Cycle Number
(1-255)
LUC 3
Lucky Cycle Display Op-
tion
On = Free vend. Lucky
cycle active after 4.25 mi-
nutes in Ready Mode.
Off = Vend must be en-
tered. Remaining vend is
free. For example, after
entering a coin the price
will count down by Coin
1 value until vend is satis-
fied.
Table 28
NOTE: When the Lucky Cycle conditions have been
met, the display will show FrEE when the display
option is set to on.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the current status.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
110 Part No. F8615401ENR4
To Next Page
Loading...
