Cycle Modifier Ultra Options CNP 3
This option allows the owner to select the options that are ena-
bled when the Ultra modifier keypad is active.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNP- appears in the
display.
4.
When CNP- appears in the display, press the START (enter)
keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNP 3 appears in the
display.
6.
When CNP 3 appears in the display, press the START (enter)
keypad.
NOTE: To go back to the current programmable op-
tion without changing the value, press the Warm (<)
keypad.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to
change the configuration value.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Each row contains a unique combination of the words ON and
OFF that indicates if that column’s feature is turned on or off
when the value is entered. Select the desired combination of fea-
tures and enter the number found in the value column.
Configuration
Value
Warm Final
Rinse (1)
Extra Rinse
Steps Agitate
Time (2)
Extra Wash
Steps Agitate
Time (3) Extra Rinse (4) Prewash (5)
0 OFF OFF OFF OFF OFF
1 OFF OFF OFF OFF ON
2 OFF OFF OFF ON OFF
3 OFF OFF OFF ON ON
4 OFF OFF ON OFF OFF
5 OFF OFF ON OFF ON
6 OFF OFF ON ON OFF
7 OFF OFF ON ON ON
8 OFF ON OFF OFF OFF
9 OFF ON OFF OFF ON
10 OFF ON OFF ON OFF
11 OFF ON OFF ON ON
12 OFF ON ON OFF OFF
13 OFF ON ON OFF ON
14 OFF ON ON ON OFF
15 OFF ON ON ON ON
16 ON OFF OFF OFF OFF
17 ON OFF OFF OFF ON
Table 12 continues...
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
80 Part No. F8615401ENR4
To Next Page
Loading...
