Configuration
Value
Warm Final
Rinse (1)
Extra Rinse
Steps Agitate
Time (2)
Extra Wash
Steps Agitate
Time (3) Extra Rinse (4) Prewash (5)
18 ON OFF OFF ON OFF
19 ON OFF OFF ON ON
20 ON OFF ON OFF OFF
21 ON OFF ON OFF ON
22 ON OFF ON ON OFF
23 ON OFF ON ON ON
24 ON ON OFF OFF OFF
25 ON ON OFF OFF ON
26 ON ON OFF ON OFF
27 ON ON OFF ON ON
28 ON ON ON OFF OFF
29 ON ON ON OFF ON
30 ON ON ON ON OFF
31 ON ON ON ON ON
(1) Warm Rinse over-rides fill temperature for Final Fill; enables Warm Rinse for the last active Fill Step in all cycles
(2) Time Added to Rinse Status Fill and Agitate Steps; adds additional time for all Agitate Steps with their Status set to Rinse 1
(3) Time Added to Wash Status Fill and Agitate Steps; adds additional time for all Agitate Steps with their Status set to Wash
(4) Modifier #2 Active Steps Enabled; turns on all Cycle Steps with Active State set to Nod 2
(5) Modifier #1 Active Steps Enabled; turns on all Cycle Steps with Active State set to Nod 1
Table 12
Cycle Modifier Deluxe Additional Wash Time CNP
4
This option allows the owner to add additional time to agitate
steps that have wash selected as their status. The additional wash
time option needs to be turned on for the Cycle Modifier Deluxe
Additional Wash Time to take effect.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNP- appears in the
display.
4.
When CNP- appears in the display, press the START (enter)
keypad.
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until CNP 4 appears in the
display.
6.
When CNP 4 appears in the display, press the START (enter)
keypad. A number will appear in the display corresponding to
the number of minutes to be added to agitate steps that have
wash selected as their status.
7. Press the Delicates Bulky (∧) or the Cold (∨) keypad to in-
crease or decrease the current number minutes.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
8. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
81 Part No. F8615401ENR4
To Next Page
