Programmable Out-
put Type Value
Mode(s) in Which
Available Signal is
Active
0 - Available Ready Mode only
1 - Available with Start Ready Mode, Start Mode
2 - Available with End of
Cycle
Ready Mode, End of Cycle
Mode
3 - Available with Start and
End of Cycle
Ready Mode, End of Cycle
Mode, Start Mode
4 - Vend is Not Satisfied Ready Mode, Partial Vend
Mode
5 - Vend is Not Satisfied
with End of Cycle
Ready Mode, Partial Vend
Mode, End of Cycle Mode
6 - Available with Vend Ready Mode, Partial Vend
Mode, Start Mode
7 - Available with Vend
and End of Cycle
Ready Mode, End of Cycle
Mode, Partial Vend Mode,
Start Mode
8 - Machine is In Use Door Locking Mode, Door
Unlocking Mode, Overflow
Mode, Pause Mode, Run
Mode
9 - Cycle is Complete End of Cycle Mode
10 - Lucky Cycle For 10 seconds when Start
Mode is entered
11 - Break in Alarm For 15 seconds when
Break in Alarm is triggered
at same time as audio out-
put tone
12 - End of Cycle is En-
tered
For 3 seconds when End of
Cycle Mode is entered
13 - Motor Running Whenever motor is running
Table 3
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Default Cycle dFtCyC
This option allows the owner to set the default cycle that the ma-
chine will enter when in the Ready Mode.
1. Control must be in Manual Mode. Refer to Entering the Man-
ual Mode.
2. Press the Delicates Bulky (∧) or the Cold (∨) keypad until
Prog appears in the display. Press the START (enter) keypad
and AtS 1 will appear in the display.
3. Press the Delicates Bulky (∧) or the Cold (∨) keypad to scroll
through the programmable options until dFtCyC appears in
the display.
4.
When dFtCyC appears in the display, press the START (en-
ter) keypad. A number will appear in the display. Refer to Ta-
ble 4 . This number corresponds to the current default cycle
value. The corresponding LEDs will also be lit.
Cycle Number on Display
Normal Hot 1
Normal Warm 2
Normal Cold 3
Permanent Press Hot 4
Permanent Press Warm 5
Permanent Press Cold 6
Delicates Bulky Hot 7
Delicates Bulky Warm 8
Delicates Bulky Cold 9
Table 4
5. Press the Delicates Bulky (∧) or the Cold (∨) keypad to in-
crease or decrease the current number to the desired number.
NOTE: To go back to the current programmable op-
tion without changing the value of the active digit,
press the Warm (<) keypad.
6. Press the START (enter) keypad when the correct value ap-
pears in the display. The new value is saved and the next op-
tion will appear in the display.
Programming Control
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
52 Part No. F8615401ENR4
To Next Page
Loading...
