EasyManua.ls Logo

Alliance Laundry Systems YTEE5ASP283CW01 - Testing Mode Keypad Entries

Alliance Laundry Systems YTEE5ASP283CW01
119 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
806221 9
General Troubleshooting
To reduce the risk of electric shock, fire, explosion, serious injury or death:
Disconnect electric power to the washer before servicing.
Never start the washer with any guards/panels removed.
Whenever ground wires are removed during servicing, these ground wires must
be
re
connected to ensure that the washer is properly grounded.
Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Table 1
Water Level Display Mode
The control will read the current water level. The
display will show the water level least significant digits
in 0.1 inch precision which will override any other
display.
If the water level is a negative value, then the right most
decimal point is lit. If the value is greater than or equal
to 10.0 inches, LED number 28 will be lit. If the value
is greater than or equal to 20.0 inches, LEDs 28 and 22
will be lit. If the value is greater than or equal to 30.0
inches, LEDs 28, 22 and 23 will be lit.
To exit this mode, the user can either press the two keys
used to enter this mode, press the Power/Cancel key, or
unplug the machine. This mode only overrides the
display, the machine will continue running any other
modes that it is in.
Testing Mode Keypad Entry
Function Keys Entry State
Enter/Exit Software Version Display Mode 7+8 Start Mode
Turn On/Off Rainbow Pizzazz Display 9+10 Start Mode
Toggle Keypad Acknowledgement 13+14 Start Mode
Toggle Suds Extra Time Mode 2+3 Start Mode and powered for less than 5 minutes
Enter Factory Test Mode 2+7 Start Mode and powered for less than 5 minutes
Enter/Exit Audit Display Mode 3+9 Start Mode
Enter/Exit Factory Test Counter Display Mode 2+9 Start Mode
Enter/Exit Show Mode 3+8 Start Mode
Enter/Exit Extra Water Mode 8+14 Start Mode and Default/Extra Water Dipswitch On
Enter/Exit Drive Version Display Mode 3+14 Start Mode
Rapid Advance Through Current Cycle Step 7+13 Run Mode
Enter/Exit Spin Retry Extra Time Toggle Mode 8+ 13 Start Mode and powered for less than 5 minutes.
Enter/Exit Water Level Display Mode 4+14 Any Mode except if Control Lock is On
Value Display # 28 Light On? # 22 Light On? # 23 Light On?
4.5 inches 45 No No No
-3.2 inches 32. No No No
12.4 inches 24 Yes No No
20.8 inches 08 Yes Yes No
42.9 inches 29 Yes Yes Yes
Tab le 2

Table of Contents

Related product manuals