90 806221
Section 9
Cycle Sequence Charts
The cycle stages are dependent on the cycle, selections
and options chosen. Not all models include all sets of
these features.
The times listed are approximate and will vary
depending on the selections and options chosen.
NOTE: The rinse water temperature will be cold,
including when optional rinses are selected.
NOTE: If No Spin is selected, all spin stages are one
minute of drain and tumble.
*Time if No Spin is selected as Spin Speed.
Normal Eco Wash Cycle (models with “A” in the 12
th
character of the model number)
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the washer before servicing.
• Never start the washer with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must
be
re
connected to ensure that the washer is properly grounded.
• Motor not grounded! Disconnect electric power before servicing motor.
W485
WARNING
Stage Step Time
Default
Time
Speed Dispensers
Water
Valves
Pump
Gravity
Drain
INITIAL
DRAIN
Drain 0:10 0:10 Off Off Off C Open
WETTING Fill/Agitate 2:30 2:30 WA Det/Bl, ES1
H, W, C,
TC
Off Closed
SOAK
(optional)
Soak
Fill/Agitate
3:00 0:00 LA, Off Off
H, W, C,
TC
Off Closed
Soak Soak 30:00 0:00 SA, Off Off
H, W, C,
TC
Off Closed
Soak
Distribute/
Pump
1:00 0:00 D Off Off C Open
PRE-
WAS H
(optional)
Prewash
Fill/Agitate
6:00 0:00 WA Off
H, W, C,
TC
Off Closed
Prewash
Distribute/
Pump
1:00 0:00 D Off Off C Open
HEAT
(heater
models
only)
Heat
Fill/Agitate
2:00 0:00 WA Det/Bl, ES1
H, W, C,
TC
Off Closed
Heat
Heater
28:00 0:00 WA Off
H, W, C,
TC
Off Closed
(continued)
To Next Page
Loading...
