11
Chapter 4
Configuration
The configuration in Figure 3 demonstrates how the AT-MR118FT and
AT-MR128FT can be used to link two networks. In this scenario, two buildings are
linked by fiber optic cabling and the signals are distributed by UTP. This technique
takes advantage of the stronger fiber optic signal and the less expensive UTP
signal technique.
The figure assumes that the MDI-X switch has been activated on both
the AT-MR118FT and AT-MR128FT repeaters, enabling a hub-to-hub
connection. See Appendix A for more information.
Figure 3: Typical Hub Configuration
ote
To Next Page
Loading...
