12
Ground loops
Unsuitable connections can lead to different potentials between the camera
system GND and the environmental shield/chassis GND caused by ground loops.
This can damage the camera and the connected devices or cause malfunctions.
• Avoid potential differences between the camera housing and GND.
• All wiring must be done by authorized personnel, according to the
corresponding technical standards.
• Read the description in the user guide carefully.
FPC connectors
Hirose FH55-22S-0.5SH FPC connectors enable
compact camera design. The small-sized
connectors are sensitive to mechanical stress
and are specified for maximum 20 mating/
unmating cycles. Especially if you are inexperienced with this connector, be very
cautious. If the FPC connector is broken, the camera must be replaced. To install
and operate cameras safely, read the instructions in the user guide carefully.
Actuator Connector rearConductors
To Next Page
Loading...
