26
33
Cat:The engine has a serial number plate (A, Figure34)
attached near the top of the engine.
34
Isuzu:The engine has a serial number plate (A, Figure135)
attached on top of the engine.
35
Troubleshooting
Before performing any troubleshooting procedures,
readSafetyand obey the following safety messages.
For engine and generator troubleshooting, refer to the Engine
Operator's Manual and Generator Operator's Manual, or
contact your dealer.
WARNING
Electrocution Hazard
• Ballast and capacitors are capable of discharging high
voltage. Only qualified electricians should service or
perform replacement procedures.
• High voltage is present when engine is running. Never
attempt to service electrical components while engine is
running.
WARNING
Burn Hazard
• The light fixtures become extremely hot during use.
• Always use caution and heat–resistant gloves when
handling the lights or allow the lights to sufficiency cool
down before handling.
Always follow the electrical component manufacturer
specifications for voltage and test procedures.
Troubleshooting Chart
Problem Possible Cause Remedy
Breaker(s) in outlet box not
turned on or tripped.
Turn on / reset breakers.
Lights not allowed ample time
to cool after operation.
Allow 15 minutes between
shutting down and restarting
lights.
Connection between light bar
and fixture(s) not secure.
Check and secure
connections.
Lamp(s) not screwed in
securely.
Tighten lamp(s).
Lamp(s) burned out or
broken.
Replace lamp(s).
Wrong style replacement
lamp(s) installed.
Install correct replacement
lamp(s).
Too much power being drawn
from auxiliary outlets.
Remove load(s) from auxiliary
outlets.
Light(s) not
operating
Temperature of ballast below
-29°C (-20°F).
For operations where
temperature of ballast falls
below -29°C (-20°F), some
means of warming ballast must
be used.
For all other issues, contact your authorized dealer.
Specifications
Overall Dimensions
Dimension Imperial Metric
Length - Towing
Transport
10 ft - 6 in 3,20 m
To Next Page
Loading...
