Allworx
®
Verge™ IP Phone Series User Guide
Page 62 866.ALLWORX * +1 585 421 3850
www.allworx.com
Version: T Revised: February 14, 2019
To update the Audio Message Center settings:
The Audio Message Center settings enable updating the presence setting, name recording, managing
the greetings, or updating the Allworx PIN.
1. Log in to the Audio Message Center and press 4 on the Verge IP phone numeric keypad.
Key
During
message
After
message
Option
*1 1
Reply to this message - Allworx Users only.
• Enter an extension to reply to the message. The Allworx system plays the selected user’s
contact information. Select one of the options:
• Record a message, and then press the # key when complete. Select one of the following
options:
*2 2
Forward this message - Allworx Users only. Follow the steps for Reply to this message.
NOTE: Recording an introduction is not required prior to forwarding the voicemail message.
*3 3
Delete the message.
*4 4
Replay this message.
*6 6
Play the next message.
*9 9
Place a call to the sender of this message, if the call is from an internal Allworx phone.
*# #
Return to the previous menu.
** *
Listen to these choices again.
Note:
Send Voicemails directly to users without accessing the Audio Message Center. Dial 3 + extension.
Note:
Digits may vary per system. Please check phone functions tab of the My Allworx Manager page or consult
the Allworx administrator.
• <extension number>
Enter another user’s extension for the voicemail message.
• 9
To send the message to each Allworx user on the system - if enable
(digits may vary per system). Please check phone functions tab of
the My Allworx Manager page or consult the Allworx administrator
Key Option Key Option
1 or hang up
Send the message
#
Cancel the message
2
Review the message
*
Hear these options again
3
Change the message