Need help?Do you have a question about the Allworx 9202 and is the answer not in the manual?
Provides step-by-step instructions for connecting the Allworx 9202 VoIP phone to the network and power.
Details blind and attended transfer procedures for calls.
Step-by-step guide for setting up and managing conference calls.
How to mute the microphone or enable Do Not Disturb mode.
Instructions on placing calls on hold and retrieving them.
Explains how to place outbound calls using different PFKs.
Lists features that can be programmed into the phone's PFKs by the System Administrator.
Instructions for enabling and disabling the Do Not Disturb feature.
Details on logging in/out of queues and placing/retrieving calls from queues.
How to access and use the Allworx Message Center for voicemails.
Lists options available via the CONFIG soft key for phone settings.
Instructions for setting up and using personal speed dial numbers.
Guide to checking network settings like DHCP and VLAN.
Steps to reset the phone to its factory default configuration.
General| Headset Support | Yes |
|---|---|
| Protocols | SIP |
| Wall Mountable | Yes |
| Ports | 2 RJ45 |
| Audio | Full duplex speakerphone |
| Power | PoE or AC adapter |
| Ethernet Ports | 2 (10/100 Mbps) |
| PoE | Yes (802.3af) |
| Supported Codecs | G.711, G.729 |
| Headset Port | RJ-9 |
| Power Supply | Optional |
To Next Page
