Phone Guide - 9202
2. Highlight Reboot Phone.
3. Press the Select button
.
4. If you have any unsaved changes, you’ll be asked if you want to save them before rebooting. Select the
YES soft key to save any changes OR select NO to cancel changes made.
5. Select the YES soft key on the next confirmation prompt to reboot.
7.5 Clear Call History
The Allworx phone retains the history of your calls up to 99 calls. You can clear your call history by using the
following steps:
1. Select the CONFIG soft key.
2. Scroll down and highlight Clear Call History.
3. Press the Select button
.
4. Select the YES soft key to clear call history OR select NO to cancel.
7.6 Refresh Directory
If new users or extensions have been set up on the Allworx server, the on-phone directory will automatically be
updated after some delay. The directory may be updated immediately using the following procedure:
1. Select the CONFIG soft key.
2. Scroll down and highlight Refresh Directory.
3. Press the Select button .
4. Select the EXIT soft key to exit the Refreshing the Directory screen.
7.7 Check the Network Settings
Warning: Do not make any changes to your network settings unless instructed by your System
Administrator.
1. Select the CONFIG soft key.
2. Scroll down and highlight Network Settings.
3. Press the Select button
.
a.
DHCP – Allows the phone to extract its configuration from the server.
i. Enabled (Default)
ii. Disabled
b.
VLAN – Allows the phone to stay on the same network without any hardware reconfiguration.
i. Enabled
ii. Hub Debug Mode
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2008 Allworx. All rights reserved.
Revised: May 28, 2008
Page 20
To Next Page
Loading...
