SHANGHAI ALLYNAV TECHNOLOGY CO., LTD.
Address: Room 201, Building 1, No,99, Lane 215, Gaoguang Road, QingPu District, Shanghai,
MODE BASE
Set start coordinate of R30 receiver. We need use command feedback
form last command to edit this command.
MODE BASE 31.16230632665 121.30707809099 24.9839
Interface show as blow:
Figure 17 MODE BASE
19
IP information obtain steps:
1.
Plug the internet cable which should connect to R30 on lattop.
2.
Click
Win+R on keyboard to operating “Run”.
3.
Type in “cmd”
4.
Click “OK” for next step.
To Next Page
