T1 - Omron Control INSTRUCTION MANUAL Page 2
SHAW-ALMEX INDUSTRIES LIMITED 49900-030 October 2000
Revised Mar03, Jun04, Aug04, Jun05
Table of Contents
1.
RECORD OF PURCHASE................................................................................................................3
2.
DECLARATION OF CONFORMITY.................................................................................................4
3.
SAFETY..............................................................................................................................................5
3.1.
Definition of Pictograms.......................................................................................................5
3.1.1. Electrical Hazard ............................................................................................................5
3.1.2.
Burning Hazard ..............................................................................................................5
3.2. Limitation of use ..................................................................................................................5
4.
ASSEMBLY........................................................................................................................................6
4.1. Unpacking............................................................................................................................6
4.2.
Temperature Control Panel Features..................................................................................6
4.3. Functional Diagram .............................................................................................................6
4.4. Connection Assembly..........................................................................................................7
5.
OPERATION ......................................................................................................................................7
5.1. Temperature Control Settings .............................................................................................7
5.1.1. Setting the Platen Temperature................................................................................................7
5.1.2. Applying and Removing Protection to Settings ......................................................................7
5.1.3. Setting Temperature Units to °C or °F ....................................................................................8
5.2. Heating the Vulcanizer ........................................................................................................8
5.3. Manual Override ..................................................................................................................8
5.4. Temperature Control ...........................................................................................................8
6.
MAINTENANCE.................................................................................................................................9
6.1. Opening the Control Cabinet (T1R2 Models)......................................................................9
6.2. Removing Control Panel from the Frame (T1F2, T1F3 Models).........................................9
6.3. Temperature Calibration......................................................................................................9
6.3.1. Auto Tune.............................................................................................................................10
6.3.2. Temperature Offset................................................................................................................10
7.
TROUBLESHOOTING ....................................................................................................................11
7.1. No Display on Temperature Controller..............................................................................11
7.2. Error Display on Temperature Controller ..........................................................................11
7.3. Vulcanizer Not Heating......................................................................................................11
7.4. Vulcanizer Over Heating ...................................................................................................12
7.5. Controller will not maintain Set Point Temperature...........................................................12
8.
Service..............................................................................................................................................12
8.1. Emergency Service ...........................................................................................................12
8.2. Return of Goods Authorization ..........................................................................................12
8.3. Guarantee..........................................................................................................................12
To Next Page
Loading...