Why is the battery indicator constant on in my Alnor Balometer ABT701 Measuring Instruments?
If the battery indicator is constantly on, it means the batteries are fully depleted and need to be replaced.
What to do if no LEDs light up on Alnor Balometer ABT701 Measuring Instruments?
If no LEDs light up on your Alnor Measuring Instruments, here's what you should do: * First, ensure the unit is turned on by pressing the I/O key. * If it still doesn't work, the batteries may be low or dead; replace them. * Also, check for dirty battery contacts and clean them if necessary. * If none of these steps work, the meter may be damaged and require a return to the factory for service.
What to do if the Alnor Balometer ABT701 Measuring Instruments unit powers on, but automatically turns itself off shortly thereafter?
If your unit powers on but then turns off shortly after, the batteries are likely fully depleted. Replace them to resolve this issue.
Why is the battery indicator blinking on my Alnor Balometer ABT701?
A blinking battery indicator means that the batteries are becoming depleted and should be replaced.
What to do if meter needle does not move with flow stimulus on Alnor Measuring Instruments?
If the meter needle isn't moving with the flow stimulus, try the following: 1. Ensure the unit is turned on by pressing the I/O key. 2. Replace the batteries if they are low or dead. 3. Clean the battery contacts if they are dirty. 4. If 1 Range LED is also blinking, the meter might be in flow “Hold” condition; press and release the hold button. 5. If none of these steps resolve the issue, the meter may be damaged and need to be returned to the factory for service.
What does it mean when Supply and Return LEDs blink On and Off on Alnor Measuring Instruments?
If the Supply and Return LEDs are blinking on and off, it indicates that the sensor cable is likely disconnected from the meter. Verify that the sensor cable is properly connected. If the problem persists, the flow sensor or cabling may be damaged and require a return to the factory for service.
What does it mean if 1 Range LED is blinking on Alnor Balometer ABT701?
If one Range LED is blinking, the meter is in flow “Hold” condition. To resume normal flow reading, press and release the hold button.
How to fix meter needle that does not deflect to full-scale position during power-on sequence on Alnor Balometer ABT701?
If the meter needle does not deflect to the full-scale position during the power-on sequence, verify the correct meter needle zero adjustment. If the issue persists, the meter may be damaged and need to be returned to the factory for service.
What to do if all 3 Range LEDs blink On and Off on Alnor Measuring Instruments?
If all 3 Range LEDs blink on and off, the meter may be damaged and need to be returned to the factory for service.
Important safety warnings regarding the use of the air balancing instrument.
Guide to assembling the fabric hood and frame onto the instrument base for use.
Steps for securely connecting the analog meter to the capture hood base.
A detailed walkthrough of performing air flow measurements with the ABT capture hood.
Solutions for common symptoms like no power, incorrect readings, or error indicators.
General| Type | Balometer |
|---|---|
| Model | ABT701 |
| Resolution | 1 cfm |
| Temperature Range | 32 to 122°F (0 to 50°C) |
| Operating Temperature | 32 to 122°F (0 to 50°C) |
| Storage Temperature | -4 to 140°F (-20 to 60°C) |
| Data Logging | Yes |
| Accuracy | ±3% of reading |
| Battery Life | 8 hours |
| Display | LCD |
| Weight | 1.1 kg |
| Flow Range | 25 to 2, 500 cfm (42 to 4, 250 m3/h) |
To Next Page
