48
８．３ Yearly maintenance
⑤ Check of water level of exhaust cooling tank
● How to check
１． Detach the right side panel using phillips-head screw driver.
２． Check if the water level of exhaust cooling tank has a range of below figure.
In case of water lack, pour water into the tank referring to
４．５ Standard accessories.
３． Attach the right side panel using phillips-head screw driver.
Do not pour too much water into exhaust cooling tank.
It makes overflow which may cause malfunction and/or breakage of autoclave.
Be sure to stopple the funnel after pouring water into exhaust cooling tank.
Water in exhaust cooling tank reduces faster therefore frequent water supply is required.
⑥ Periodic inspection
Make sure you inspect the autoclave at least once in a year referring to
“Periodic inspection manual” owned by a distributor in your region.
Failure to this periodic inspection, it may cause not only shortening life of autoclave
itself, but also a fatal accident by a defect of main parts.
※The lid cover and the operation panel may turn yellow due to aged deterioration by
ultraviolet.
3 to 4cm
CAUTION
To Next Page
