Alpha ESS M4856-P - Installation

______________________________________________________________________
Alpha ESS Co., Ltd.
Page 13 of 29
Your Smart Energy
Installation
Where the top of the M4856-P is within 1200 mm of the ceiling or structure above the
M4856-P, the ceiling or structure surface shall be suitably non-combustible for an area of
600 mm past the extremities of the M4856-P.
M4856-P shall be mounted with the highest point no greater than 2.2 m above the floor or
platform.
Installation
Step 1: open the battery package.
Note: The box must be placed in the direction of the label and only remove the
packaging in upwards direction. Removing the packaging in other directions is wrong.
Step 2: Pull off the buckle located in the middle of the bottom.
Pull the top two guide rods to remove the front panel.