Alpha ESS M4856-P - Page 16

______________________________________________________________________
Alpha ESS Co., Ltd.
Page 14 of 29
Your Smart Energy
Installation
Step 3: Use a screwdriver to assemble the
battery mounting brackets onto the battery
back panel.
Step 4: Push the battery firmly against the wall and use a level to confirm the position of the
battery. Please drill four holes (two on each side) directly on the wall at the marking positions
of the brackets with an impact drill (bit φ 8.0mm, length 20cm) and the depth of each hole should
be about 7 cm.
Note: 1: Check installation space.
2: Pack the PE bag on the battery to block out the dust before drilling.