010-619-J0 Rev B Page 11
3.3 Overview of the CXCM1 HP
CXC HP in-shelf controllers have a small organic LED (OLED) display. This display shows 30 charac-
ters total (five lines high, six characters wide) and the controller has three navigation buttons and one
reset button.
The in-shelf display has three main operating modes: dashboard, menu and screen saver. After 20
minutes with no activity, the in-shelf controller goes into screen saver mode and the display shuts off.
From screen saver mode, press any of the three navigation buttons to re-activate the screen and enter
dashboard mode.
Figure 7: CXCM1 HP Controller
3.3.1 Display
In dashboard mode, the in-shelf display shows the key operating parameters of a system. For example,
output voltage and load current. If more than one system is defined, you can cycle between systems
using the Forward and Back buttons. With multiple systems, you can specify a default system, which
is then displayed first.
Refer to the software manual for set up.
The following figure below shows examples of the screens.
System Status LEDs
LED Screen
Forward and Back Buttons
to scroll through Menus
and Select button to Execute
Ethernet Port
USB Port
Reset
To Next Page
Loading...