Alpha Technologies Cordex HP 48 1.2kW - In-Shelf Display: Menu; Figure 8: In-Shelf Controller Dashboard Screens; Figure 9: In-Shelf Controller Menu

010-619-J0 Rev B Page 12
Figure 8: In-Shelf Controller Dashboard Screens
3.3.2 In-Shelf Display: Menu
From the dashboard, use the Select button to enter a menu. From the menu, the OLED display lets you
execute a set of commands much like the LCD screens on the CXC HP.
When you enter a menu, the top item is highlighted. To go to another menu scroll through using the
Forward and Back buttons. To execute a highlighted menu item, press the Select button.
To exit a menu and return to the main dashboard, scroll to the Back command, and then press the
Select button. The figure below shows an example of the menu screen. The following table provides a
full list of menus available via the in-shelf display.
Figure 9: In-Shelf Controller Menu
AC-120
120.1V
7872VA
8023VA
7902VA
DC--48
54.09V
103.1A
Float
DC--24
26.92V
37.23A
System
Output Type
AC or DC
Nominal
Output
Voltage
Output Voltage
Phase 1 Output Power
Phase 2 Output Power
Phase 3 Output Power
Output Voltage
Output Voltage
Output Current
Output Current
Battery Mode
Table 1: In-Shelf Controller Full Menu (Sheet 1 of 2)
Menu Label Description
ALCO Perform the alarm cut-off command
Reset Perform a software reset of the controller
IPv4 Display the IPv4 address, subnet and gateway for this controller
IPv6 Display the IPv6 addresses assigned to this controller
Menu
ALCO
Reset
IPv4
IPv6
ALCO