Chapter 2 Installation and Wiring
8
Chapter 2 Installation and Wiring
2.1 External Dimension and Installation Dimension (see Appendix 1)
2.2 Mounting Place Requirements and Management
Attention
·Don’t carry the driver by its cover. The cover cannot support the weight of
the driver and the driver may drop.
·Please install the driver on a strong support, failing which the driver may
fall off.
·Don’t install the driver in places where water pipes may leak onto it.
·Don’t allow screws, washers and other metal foreign matters to fall inside
the driver, otherwise there is a danger of fire or damage.
·Don’t operate the driver if parts are not complete, otherwise there is a
danger of fire or human injury.
·Don’t install the driver under direct sunshine; otherwise, it may be
damaged.
·Don’t short circuit PB, + and -, otherwise there is a danger of fire or the
driver may be damaged.
·Cable lugs must be connected to main terminals firmly.
·Don’t apply supply voltage (AC 220V) to control terminals except
terminals TA, TB, TC.
Please mount the driver as following instructions and maintain appropriate conditions
2.2.1 Installation Location
The installation location should meet the following conditions:
Good indoor ventilation
Ambient temperature: -10 °C ~ 40 °C. If the temperature is higher than 40 °C,
forced ventilation or derating use is required.
To Next Page