Alpina B 1.0 EJ - Technical Specifications

EN
12 TECHNICAL SPECIFICATIONS
10. TECHNICAL SPECIFICATIONS
B 1.0 EJ
Power supply voltage V~ 230
Power supply frequency Hz 50
Motor Power W 1000
Cutting width
with line cutter head
with 3-point blade
cm
cm
37
20
Mass
with line cutter head
with 3-point blade
kg
kg
4.95
4.98
Maximum tool rotation speed
with line cutter head
with 3-point blade
min
-1
min
-1
5500
7300
[1]
Notice: The vibration value indicated was determined with a standardized tool and can be used to make comparisons with other electric
equipment as well as temporary estimates of the load through the vibrations.
WARNING!
The vibration value may vary according to the usage of the machine and its tted equipment, and be higher than the one indicated. Safety
measures must be established to protect the user and must be based on the load estimate generated by the vibrations in real usage conditions.
In this regard, all the operational cycle phases must be taken into consideration, such as switching o or idle running.
The noise level may vary according to machine usage if working or running idle.
Maximum noise and vibration levels [1] B 1.0 EJ
Acoustic pressure level
Measurement uncertainty
dB(A)
dB(A)
84,6
3
Measured acoustic power level
Measurement uncertainty
dB(A)
dB(A)
97,1
3
Guaranteed acoustic power level dB(A) 99
Vibration level
Measurement uncertainty
m/sec
2
m/sec
2
2,98
1,5