Why is my Alpine Spas Hot Tub not heating up?
If your Alpine Spas Hot Tub isn't heating, make sure it's not in rest, away, or sleep mode. Switch it to ready or normal mode. Also, increase the set temperature.
What to do if my Alpine Spas Hot Tub has no power?
If your Alpine Spas Hot Tub has no power, first check that the RCD is turned on. Then, have an electrician check the plug and wire connections.
What to do if my Alpine Spas Hot Tub doesn’t reach set temperature?
If your Alpine Spas Hot Tub doesn’t reach the set temperature, it might be in rest, away, or sleep mode. Change the mode to ready or normal.
Why does the RCD trip on my Alpine Spas Hot Tub?
If your Alpine Spas Hot Tub RCD trips, have an electrician check that the wiring is correct and matches the diagram. It could also be a component failure, so call for service.
How to fix low jet pressure in my Alpine Spas Hot Tub?
If you have low jet pressure in your Alpine Spas Hot Tub, turn the jet face anti-clockwise to open it. If you have a 2-Speed Pump, press the jet button again to enter high speed.
What to do if there is no jet pressure in my Alpine Spas Hot Tub?
If there's no jet pressure in your Alpine Spas Hot Tub, try priming the pump by pressing the jets button on and off 2-3 times in sequence. Also, bleed the pump by loosening the barrel union.
Why are the speakers not working on my Alpine Spas Hot Tub?
If the speakers aren't working on your Alpine Spas Hot Tub, ensure the Bluetooth light is activated when pressing the on button. Also, remove any protective case from your device and try again, as it may be interfering.
How to fix a blank display on my Alpine Spas Hot Tub?
If the display on your Alpine Spas Hot Tub is blank, switch the spa pool off and on again.
Why does my Alpine Spas Hot Tub emit a high pitch ringing noise?
If your Alpine Spas Hot Tub emits a high-pitched ringing noise, check for leaking around the UV chamber and replace the UV bulb if necessary, as this indicates a UV system alarm because the bulb has failed.
Comprehensive safety precautions for installation, use, and electrical components.
Guidance on choosing a position, drainage, and service access.
Steps to prepare the spa pool before filling with water.
Critical warning about maintaining proper water levels to prevent damage.
Instructions for filling spa pools with a grate skimmer.
Instructions for filling spa pools with a floating weir skimmer.
Information on electrical requirements and model-specific wiring.
Details for setting up a 15A spa pool, including load-shedding.
Details for setting up 25A or 32A spa pools requiring hardwiring.
Step-by-step guide to installing filter cartridges for specific models.
Step-by-step guide to installing filter cartridges for specific models.
Automatic startup sequence, priming, and heat-up process.
Importance of water balance and sanitization for spa health.
Setting duration and frequency for spa pool filter cycles.
Configuring the total daily filtration hours for the spa.
Defining the time intervals between filter cycles.
Instructions for accessing internal components for inspection.
Step-by-step guide on how to drain the spa pool using the external valve.
Procedures for quick and soak cleaning of filter cartridges.
Steps to clean internal plumbing to remove bio-film and bacteria.
Detailed instructions for safely shutting down the spa pool for extended periods.
A checklist for weekly, monthly, and quarterly spa maintenance tasks.
Guide to diagnosing and resolving general and water-related problems.
Explains error messages on the control panel and required actions.
General| Dimensions | 230 x 230 x 97 cm |
|---|---|
| Heater | 3kW |
| Ozone | Yes |
| LED Lighting | Yes |
| Seating Capacity | 6 persons |
To Next Page