Why is my Alpine Spas Hot Tub not heating up?
If your Alpine Spas Hot Tub isn't heating, make sure it's not in rest, away, or sleep mode. Switch it to ready or normal mode. Also, increase the set temperature.
What to do if my Alpine Spas Hot Tub has no power?
If your Alpine Spas Hot Tub has no power, first check that the RCD is turned on. Then, have an electrician check the plug and wire connections.
What to do if my Alpine Spas Hot Tub doesn’t reach set temperature?
If your Alpine Spas Hot Tub doesn’t reach the set temperature, it might be in rest, away, or sleep mode. Change the mode to ready or normal.
Why does the RCD trip on my Alpine Spas Hot Tub?
If your Alpine Spas Hot Tub RCD trips, have an electrician check that the wiring is correct and matches the diagram. It could also be a component failure, so call for service.
How to fix low jet pressure in my Alpine Spas Hot Tub?
If you have low jet pressure in your Alpine Spas Hot Tub, turn the jet face anti-clockwise to open it. If you have a 2-Speed Pump, press the jet button again to enter high speed.
What to do if there is no jet pressure in my Alpine Spas Hot Tub?
If there's no jet pressure in your Alpine Spas Hot Tub, try priming the pump by pressing the jets button on and off 2-3 times in sequence. Also, bleed the pump by loosening the barrel union.
Why are the speakers not working on my Alpine Spas Hot Tub?
If the speakers aren't working on your Alpine Spas Hot Tub, ensure the Bluetooth light is activated when pressing the on button. Also, remove any protective case from your device and try again, as it may be interfering.
How to fix a blank display on my Alpine Spas Hot Tub?
If the display on your Alpine Spas Hot Tub is blank, switch the spa pool off and on again.
Why does my Alpine Spas Hot Tub emit a high pitch ringing noise?
If your Alpine Spas Hot Tub emits a high-pitched ringing noise, check for leaking around the UV chamber and replace the UV bulb if necessary, as this indicates a UV system alarm because the bulb has failed.
Section to record spa pool details and warranty information for future reference.
Essential steps to prepare the spa pool before filling with water to prevent damage.
Step-by-step guide on how to correctly fill the spa pool with water.
Guidance on electrical connections and powering up the spa pool safely.
Instructions for installing the filter cartridges for both floating weir and grate skimmers.
Steps for automatically starting the spa pool and the heating process.
Guide to maintaining water quality through balancing and sanitizing.
Overview of the topside control panel functions and button operations.
The central computer system and heater that controls all spa pool components.
Step-by-step guide on how to operate the drain valve and drain the spa pool.
Procedures for quick cleaning, soaking, and replacing spa pool filters.
Steps to perform a pipe clean to remove bio-film and maintain plumbing.
Instructions for safely preparing the spa pool for hibernation or long-term shutdown.
Contact details for email and phone support for unresolved issues.
Guide to resolving common issues with the spa pool, categorized by water and general problems.
Explains common diagnostic messages, their causes, and required actions.
General| Brand | Alpine Spas |
|---|---|
| Model | FUJI |
| Category | Hot Tub |
| Language | English |
To Next Page