Why is my Alpine Spas Hot Tub not heating up?
If your Alpine Spas Hot Tub isn't heating, make sure it's not in rest, away, or sleep mode. Switch it to ready or normal mode. Also, increase the set temperature.
What to do if my Alpine Spas Hot Tub has no power?
If your Alpine Spas Hot Tub has no power, first check that the RCD is turned on. Then, have an electrician check the plug and wire connections.
What to do if my Alpine Spas Hot Tub doesn’t reach set temperature?
If your Alpine Spas Hot Tub doesn’t reach the set temperature, it might be in rest, away, or sleep mode. Change the mode to ready or normal.
Why does the RCD trip on my Alpine Spas Hot Tub?
If your Alpine Spas Hot Tub RCD trips, have an electrician check that the wiring is correct and matches the diagram. It could also be a component failure, so call for service.
How to fix low jet pressure in my Alpine Spas Hot Tub?
If you have low jet pressure in your Alpine Spas Hot Tub, turn the jet face anti-clockwise to open it. If you have a 2-Speed Pump, press the jet button again to enter high speed.
What to do if there is no jet pressure in my Alpine Spas Hot Tub?
If there's no jet pressure in your Alpine Spas Hot Tub, try priming the pump by pressing the jets button on and off 2-3 times in sequence. Also, bleed the pump by loosening the barrel union.
Why are the speakers not working on my Alpine Spas Hot Tub?
If the speakers aren't working on your Alpine Spas Hot Tub, ensure the Bluetooth light is activated when pressing the on button. Also, remove any protective case from your device and try again, as it may be interfering.
How to fix a blank display on my Alpine Spas Hot Tub?
If the display on your Alpine Spas Hot Tub is blank, switch the spa pool off and on again.
Why does my Alpine Spas Hot Tub emit a high pitch ringing noise?
If your Alpine Spas Hot Tub emits a high-pitched ringing noise, check for leaking around the UV chamber and replace the UV bulb if necessary, as this indicates a UV system alarm because the bulb has failed.
Essential safety warnings and precautions for spa pool installation and use.
Guidance on selecting a location and preparing the base for the spa pool.
Crucial steps to follow before filling the spa pool to prevent damage or warranty issues.
Warning about maintaining minimum water levels to prevent component damage.
Detailed steps for filling spa pools with a grate skimmer system.
Guidance on electrical connections and powering up the spa pool.
Instructions for setting up a 15A spa pool, including load-shedding details.
Instructions for setting up 25A or 32A spa pools requiring dedicated electrical supply.
Procedures for automatically starting up and heating the spa pool.
Instructions for balancing and sanitizing spa pool water for optimal quality.
Step-by-step guide on how to safely drain the spa pool water.
Procedures for quick and soak cleaning of spa pool filters.
Procedure for cleaning internal spa pool plumbing to remove bio-film.
Instructions for safely preparing the spa pool for long-term hibernation.
How to check spa pool pumps for leaks, corrosion, and proper operation.
Contact information for email and phone support for technical issues.
General troubleshooting guide for common spa pool issues and solutions.
Troubleshooting guide for common spa pool water quality issues.
Explanation of diagnostic messages displayed on the topside control panel and required actions.
General| Brand | Alpine Spas |
|---|---|
| Model | COLORADO |
| Category | Hot Tub |
| Language | English |
To Next Page