Alpine 7279M - Page 50

GT SERIES
. Figure A)
a: sReplncemnent of Mute: oxciteh °C: Poatd (GT75B11A,/GT75B11C,/GT75B11D models only)
(GT75B Series model only)
Cae we
‘ie ja oe ‘ i
(1) Heiove one screw marked * as shown in {Mute Switeh PC: Board |
Figure 8. \ |
(2) After replacing with a good one, assemble the P. ' GT Control '
C. Board using disassembly instructions in reverse P. C. Board \
1
order. ' 1
(On GT75B11A/GT75B11C/GT75B11D models 1
ack RF Frame i
fgets ; Bracket 4
(1) Remove two screws marked “%” as shown in lens pele i pee oe
Figure A.
(2) After replacing with a good one, assemble the P.
C. Boards using above steps in reverse order.
Figure @)
Motor RF Frame Bracket
(GT75B Series model only) | GT Control P.C. Board $$ ypo 7” = =a
i F)_ Mute Switch}
. P. C. Board 1
eg ene ae Sn a Neat 1
GT75B01A
GT75B01B
GT75B01C
GT75B01D
GT75BO1L
models only,
Cassette Holder |
Figure 8
Solders
Solders
Solder
Solder Solder x Solders
Solders
Solder GT Control P. C. Board
(GT75B Series mode! only) (GT75L010/GT75L110/GT75L220 models only)
Figure 9 Figure 9