Alpine 7290M - Radio Reception Modes

4. After finishing Auto Memory Preset, it tunes in the station memorized onto the .
Address No. 1. If no station is memorized, it returns to Ue eo station uy were
listening to before we auto BiSInony eee Riper ag PHSRAR Lots? rheas
Preset Tuning : :
After the preset stations have heen memorized, you can. tune in- your desired s station
with just a touch.of a switch.
1. Select the tuning band (FM1, FM2, MW or LW) © with the TUNER/BAND selec!
switch ©.
2. Press any one of the preset switches (8 and the nuniber (1 — 6) will illuminate | in the
display
@.
.
.
D.A.P. (Direct Access Preset)
This feature allows the storage of FM, MW and LW presets on the same band.
To.memorize stations into D.A.P., follow the same procedures as in Manual Memory
Preset on. page 9.
To Access the D.A.P. Presets
1. Press the D.A.P. switch @. The D.A.P. indicator ® will illuminate in the display.
2. Press any one of the preset switches @® and the number (1 — 6) will illuminate in the
display.
FM Stereo/Monaural Selection (MONO Switch)
During stereo reception, should the signal level become weak (the ST indicator @ in the
display blinks), select monaural reception by pressing the MONO switch @ to decrease
noise level.
NOTE:
Monaural mode has been set initially. Push the MONO switch @8 when a stereo
broadcast Is being received.
Local/Distance Switch Operation
You may select local or distance mode during SEEK tuning. When it is in the local
mode (Distance (DX) indicator @ is off), it allows you to tune in strong signal stations only
(stations C, F, H and L as shown below). When it is in the distance mode (Distance (DX)
indicator @0 is on), weak and strong signal stations (stations from A through M) will be
tuned in.
Once a station is tuned in by SEEK in local mode, the mode will automatically switch to
- distance mode for optimum reception.
lad ad da ta dhs
Station Frequencies
Signal Strength
im m
NOTE:
DX (Local/Distance) switch @ functions only in SEEK tuning.
10