Alpine 7290M - Radio Tuning and Presets

e RADIO OPERATION
Manual and Automatic Seek Tuning
1.
Turn
on
the
power
by
turning
the
VOLume
control/
pawer
switch
@
clockwise.
Continue
to
rotate it
until
the
desired
volume
level is
reached.
2. Push the TUNER/BAND select switch (8 for reception of MW, LW or FM (FM 1 or
FM2). The Radio Band indicator © will be on, and the ST [stereo] indicator @@: will also
be on during FM stereo reception.
3. Adjust the BASS ©, TREBle @, BALance @, and FADer controls to thair déhter
» positions. ©
4. To automatically tune, press the TUNE switch @ and then either UP @ or DN @ tuning
switch. The SEEK indicator @ appears on the display and the frequency changes to
- indicate that the radio is in the auto SEEK tuning mode and ready to stop at every
strong station. Repeat the procedure until your desired station is obtained. When the
radio reaches the upper or lower end of the band, it automatically starts scanning in
the opposite direction. To return to manual tuning, press the TUNE switch a second
time, the SEEK indicator disappears.
5.
To
manually
tune,
press
the
Tuning
switch
(UP)
®
for
higher
frequency
broadcasts,
and
press
the
Tuning switch (DN) @
for
lower
frequency
broadcasts.
6. Adjust the VOLume @, BASS ©, TREBle @, BALance @, and FADer 80, to suit your
listening preference.
7. To switch from FM to MW/LW or vice versa, press the TUNER/BAND select switch
‘Manual Memory Preset
Follow the instructions below to memorize stations for preset tuning.
1. Select the tuning band (FM1, FM2, MW or LW) © with the TUNER/BAND select
switch 4.
2. Tune in your desired station by manual tuning or Auto SEEK tuning.
3. Press any Preset switch @ for more than two seconds. The Address indicator @ in
the display will begin to blink. Press that switch a second time while the indicator is
blinking for five seconds.
4. The preset number will be memorized and will then show in the display @.
NOTE:
lf a preset memory has already been set in the same address, it will be cleared and
the new station will be memorized.
Auto Memory Preset
1. Press the TUNE switch @ and light up the A. MEMO indicator @.
2. Select the desired tuning band (FM1, FM2, MW or LW) © with the TUNER/BAND
switch 4.
3. Press the seek UP @ or DN @ switch.
It will automatically seek 6 strong stations in each band and memory the stations in
order of the signal strength from the strongest station for the Address No. 1 to the 6th
strong station for the Address No. 6. When the station is memorized, the address
indicator (No. 1 — 6) @ will appear. First, it seeks the stations in the local tuning.
lf the stations memorized are less than 6, it seeks the stations in the distance (DX)
tuning.