PARKING BRAKE
2
106 - Driving
Special feature related to
the Stop and Start
function: if the driver's
seat belt is unfastened
before the engine goes on
standby due to the Stop and Start
function, make sure that the
parking brake is applied: the
warning light appears on
the instrument panel to confirm
this.
Risk of loss of immobilisation.
The electronic parking
brake can be used to
immobilise the vehicle.
Before leaving the
vehicle, check that the electronic
parking brake is fully applied.
Application of the parking brake is
confirmed by the illumination of
the indicator light
3
on the switch
2
and the warning light on
the instrument panel until the
doors are locked. Depending on
the vehicle, a label may be
located at the top of the
windscreen to remind you.
Brief stop
To apply the electronic parking brake
manually (when stopping at a red light,
stopping when the engine is running,
etc.): pull and release the switch
2
.
The brake is released as soon as the
vehicle is started up again.
Manual operation
You can apply the electronic parking
brake manually.
Manually applying the electronic
parking brake
Pull the switch
2
. Warning light
3
and
warning light on the instrument
panel light up.
Manually releasing the electronic
parking brake
With the ignition on, press the brake
pedal then press the switch
2
: the
warning light
3
and the warning
light disappear.
To Next Page
Loading...