Alpine A110 2023 - Parking Brake; Electronic Parking Brake

PARKING BRAKE
2
Driving - 105
Electronic parking brake
Assisted operation
Applying the electronic parking
brake
With the vehicle stationary, the
electronic parking brake
immobilises the vehicle when the
engine start/stop button is pressed
1 .
In all other cases, for example,
stalling of the engine or the engine
going on standby as a result of the
Stop and Start function (refer to
"Starting, stopping the engine" and
"Stop and Start function" in Section 2),
the electronic parking brake is not
applied automatically.
Manual mode must be used.
For certain country-specific model
versions, the assisted brake
application function is not activated.
See the information on "Manual
operation".
To confirm that the electronic parking
brake is applied, the "Parking Brake
ON" message and the " " warning
light appear on the instrument panel
and the indicator light 3 lights up on
the switch 2 .
After the engine is switched off, the
indicator light 3 goes out a few
minutes after the electronic parking
brake has been applied and the
warning light goes out when the
vehicle is locked.
Note: to indicate that the electronic
parking brake is released, a beep
sounds and the "WARNING: Apply
Parking Brake" message appears on
the instrument panel:
– withtheengineon:whenthedriver’s
door is opened;
– with the ignition switched off (e.g. if
the engine stalls): when a door is
opened.
In this case, pull and release the
switch 2 to apply the electronic
parking brake.
Assisted release of the parking
brake
The brake will be released as soon as
the vehicle starts and accelerates.