GEAR CONTROL
2
96 - Driving
Automatic gearbox
Selection controls
Switches R, N and D can be used to
engage various gearbox positions:
– ( R ) position: reverse gear;
– ( N ) position: neutral;
– ( P ) position: park;
– ( D ) position: drive in automatic
mode;
– ( M ) position: drive in manual
mode.
The
5
symbol is shown on the
instrument panel to indicate which
position is engaged and the
indicator
4
indicates which gear is
engaged.
Gear change paddles 1 and 2
Paddles
1
and
2
can be used to
change gear when the gearbox is in
"manual mode" (M) or in "automatic
mode" (D).
1.
Decreaseswitchforgear(˗).
2.
Increase switch for gear (+).
Positions (P), (N) and (R) cannot be
engaged using the paddles.
Operation
With the vehicle stationary, when the
ignition is switched on and the
electronic parking brake is applied, the
indicator lights built into the R, N and D
switches will go out.
With the gearbox in position (P) or (N),
keep your foot on the brake pedal
(warning light
3
disappears from the
instrument panel) and start the engine.
To disengage the "Park" position
(P)
With the vehicle stationary and the
engine running, press the brake pedal
and select the desired position (R),
(N), (M) or (D).
To Next Page
Loading...