Alpine A110 2023 - Wiper Blades: Replacement

WIPER BLADES: REPLACEMENT
5
Practical advice - 187
Replacing the windscreen wiper
blades 1
Do not raise the window wiper arm 4 .
– Lower the windscreen wiper stalk
fully: the wiper blades will stop slightly
away from the bonnet;
– with the ignition off, press the tab 2
on the blade 1 ;
– pull the blade towards you to release
it;
– disconnect the windscreen washer
fluid pipe 3 .
Refitting
To refit the wiper blade, proceed in the
reverse order to removal. Ensure that
the blade is locked and the screen
washer fluid pipe is connected
properly.
Check the condition of the
wiper blades. You are
responsible for their service
life:
– clean the blades and the
windscreen regularly with soap
and water;
– do not use them when the
windscreen is dry;
– free them from the windscreen
when they have not been used for
a long time.
As the windscreen wiper
blades 1 are specific to
the windscreen, they
must be replaced with
equivalent windscreen wiper
blades.
Consult an approved dealer.
– In frosty weather,
make sure that the wiper
blades are not stuck by
ice (to avoid the risk of the motor
overheating).
– Check the condition of the
wiper blades.
Replace the wiper blades as soon
as their performance starts to
diminish (approximately once a
year).
Whilst changing the blade, take
care not to drop the arm onto the
window after it has been removed
as this may break the window.