Alpine A110 2023 - Page 117

TYRE PRESSURE MONITORING SYSTEM
2
Driving - 115
– press button 4 or 5 to select the trip
parameters, then use the button 2 to
browse to the "Tyre pressure: SET
(press and hold)" function on the
display 3 ;
– press and hold (for around three
seconds) on button 2 , 4 or 5 to start
resetting. The "Learning Tyre
Pressures" message is displayed for
approximately five seconds. The
request to reset the reference tyre
pressure value has been taken into
account.
Reinitialisation is carried out after a
few minutes' driving.
Note: the tyre pressure value cannot
be less than that recommended and
indicated on the edge of the driver's
door or, depending on the vehicle, on
the bottom of the driver's door.
Display
The 3 symbol appears on the
instrument panel in the event of any
tyre pressure faults (flat tyre,
punctured tyre, etc.).
« Adjust Tyre Pressure »
The warning light appears and
stays on, accompanied by the "Adjust
Tyre Pressure" message. This
indicates that at least one tyre is flat.
Check and, if necessary, readjust the
pressures of the four wheels when
cold. The warning light goes off
after a few minutes' driving.
« Puncture »
The warning light appears and
stays on, accompanied by the
"Puncture" message and a beep.
This message appears along with the
warning light.
They indicate that at least one wheel is
punctured or severely underinflated.
Replace it or contact an approved
dealer if it is punctured. Top up the tyre
pressure if the wheel is deflated.
The sudden loss of
pressure in a tyre (burst
tyre, etc.) cannot be
detected by the system.
For your own safety, the
warning light
requires you to stop
immediately, as soon as traffic
conditions allow.
« Check Tyre Pressure Sensors »
The warning light flashes for a
few seconds, then appears and stays
on, accompanied by the "Check Tyre
Pressure Sensors" message.
This message appears along with the
warning light.
They indicate that at least one tyre is
not fitted with sensors (e.g. emergency
spare wheel). In other cases, contact
an authorised dealer.
Readjustment of tyre pressures
The pressures must be adjusted
when cold (refer to the label on the
edge of the driver's door or, depending
on the vehicle, on the bottom of the
driver's door).
If the pressure cannot be checked
when the tyres are cold, the
recommended pressures should be
increased by 0.2 to 0.3bar(3PSI).