LIGHTING AND SIGNALS
1
76 - Getting to know your vehicle
Turn the ring
2
until the symbol is
opposite the mark
3
. This indicator
light on the instrument panel comes
on.
Automatic operation
Turn the ring
2
until the AUTO symbol
is opposite the mark
3
: with the engine
on, the dipped beam headlights switch
on or off automatically according to the
exterior light level, without any action
on the stalk
1
.
Main beam headlights
With the engine running and the
dipped beam headlights lit, push stalk
1
. This indicator light on the instrument
panel comes on.
To return to the dipped headlight
position, pull the stalk
1
towards you
again.
Switching off the lights
Rotate the ring
2
until the AUTO
symbol is aligned with the mark
3
. If
the main beam headlights are not
illuminated, the lights switch off once
the engine stops, the driver's door is
opened or the vehicle is locked.
Lights-on reminder audible alarm
A warning beep sounds when the
driver's door is opened to warn you
that the lights are still on.
Welcome and goodbye function
(depending on the vehicle)
Once the function is activated, the side
lights come on automatically when the
Renault card is detected or when the
vehicle is unlocked.
They switch off automatically:
– approximately one minute after
lighting up;
– when starting the engine, based on
the position of the lighting stalk;
or
– upon locking the vehicle.
Rear fog lights
Turn centre ring
4
on the stalk
until the symbol faces mark
3
, then
release it.
Operation of the fog lights depends on
the exterior lighting selected, and an
indicator light will light up on the
instrument panel.
Do not forget to switch off the fog lights
when they are no longer needed, to
avoid inconveniencing other road
users.
Switching off the lights
Rotate the ring
4
again to align the
mark
3
with the symbol corresponding
To Next Page
Loading...